Awwa C200 Standard

AWWA C Steel Water Pipe 6 In. ( mm) and Larger

Philanthropy

The weld shall be reasonably uniform width and height for the entire length of the pipe. The procedures, the welding operators as well as all operators shall be qualified under Sec. The abbreviation for each standard name is located in the upper right corner of the cover. All spiral, longitudinal, and girth seams used in the manufacture of the pipe shall be full-penetration welded butt joints.

American Water Works Association

PhilanthropyAWWA C - Steel Water Pipe 6 Inch (Mm) & Larger

The pipe shall be substantially round. By agreement between the manufacturer and the purchaser, the ends of the pipe may be supplied with joint configurations and tolerances other than those described herein. Leave a Reply Cancel reply Your email address will not be published. The test pressure shall be held for sufficient time to observe the weld seams.

American Water Works Association

For further details and information, please refer to these standards and specifications. The out-of-roundness of pipe ends shall be consistent with the diameter and wall thickness. Find a Standards Committee of Interest. By agreement between the purchaser and the manufacturer, the welding can be done either by automatic or manual means. Your email address will not be published.

These documents reflect the state of the industry. Any out-of-roundness shall be limited to a smooth oval that may be jacked back to a circular shape.

As new technologies emerge, new Standards develop. The purpose of this standard is to provide the minimum requirements for soda ash, including physical, chemical, sampling, testing, packaging, and shipping requirements. Buy Now Shop All Standards. The finished pipe shall be free from unacceptable defects. Unless specified by the purchaser, do you know enrique lyrics the wall thickness and weight tolerances for welded pipe shall be governed by the requirements of the specifications to which the plates or sheets are ordered.

Learn About Standards Development. The most important section of the foreword, it includes your options and alternatives.

Spiralco - Specifications - AWWA C

There shall be at least one set of weld-test specimens taken of each size, grade, and wall thickness from work performed by each production machine and each operator at a minimum of every ft. Standards list the expert volunteers that are responsible for creating the standard. Standards are a Valuable Resource. Each length of repaired pipe shall be tested hydrostatically in accordance with standard requirements. Yield strength, min Ksi Mpa.

Product Detail

In such cases, pipe ends shall conform to the description of detail drawings provided by the purchaser.